Chapter 5 Basic Router Configuration
Configuring a Loopback Interface
Push Button in WLAN AP
When the push button on the front panel is pressed, WLAN AP will perform both image and configuration recovery.
To perform image recovery, WLAN will go into the boot loader so that the user can download the image from the bootloader prompt.
To perform configuration recovery, WLAN AP will overwrite the contents of flash:/config.txt with the contents of
Configuring the Fast Ethernet LAN Interfaces
The Fast Ethernet LAN interfaces on your router are automatically configured as part of the default VLAN and are not configured with individual addresses. Access is provided through the VLAN. You may assign the interfaces to other VLANs if you want. For more information about creating VLANs, see the “Configuring the Ethernet Switches” section on page
Configuring a Loopback Interface
The loopback interface acts as a placeholder for the static IP address and provides default routing information.
Perform these steps to configure a loopback interface, beginning in global configuration mode:
SUMMARY STEPS
1.interface type number
2.ip address
3.exit
|
| Cisco 819 Series Integrated Services Router Software Configuration Guide |
|
| |
|
|
| |||
|
|
|
| ||
|
|
|
|