Chapter 8 Configuring the Serial Interface
How to Configure Serial Interfaces
Note You cannot use the
Encapsulation methods are set according to the type of protocol or application you configure in the Cisco IOS software.
•PPP is described in Configuring
•The remaining encapsulation methods are defined in their respective books and chapters describing the protocols or applications. Serial encapsulation methods are also discussed in the Cisco IOS Interface and Hardware Component Command Reference, under the encapsulation command.
By default, synchronous interfaces operate in
Command | Purpose |
|
|
Configures an SDLC interface for | |
|
|
Binary synchronous communication (Bisync) is a
To configure the serial interface for
Command | Purpose |
|
|
Specifies that the interface can run Bisync using switched RTS | |
| signals. |
|
|
Configuring PPP
To configure PPP, refer to the Configuring
Configuring
The synchronous serial port adapters on Cisco 819 ISRs support
Configuring Bisync
To configure the Bisync feature on the synchronous serial port adapters on Cisco 819 ISRs, refer to the Block Serial Tunneling (BSTUN) Overview. All commands listed in this section apply to the synchronous serial port adapters on Cisco 891 ISRs. Any command syntax that specifies an interface number supports the Cisco 891 ISRs slot/port syntax.
Cisco 819 Series Integrated Services Routers Software Configuration Guide
|
| |
|