Chapter 5 Basic Router Configuration
Configuring WAN Interfaces
| Command or Action | Purpose |
|
|
|
Step 6 | asynchronous mode interactive | Returns a line from dedicated asynchronous network |
|
| mode to interactive mode, enabling the slip and ppp |
| Example: | commands in privileged EXEC mode. |
|
| |
| Router |
|
|
|
|
Step 7 | ip address negotiated | Specifies that the IP address for a particular |
|
| interface is obtained via PPP and IPCP address |
| Example: | negotiation. |
|
| |
| Router |
|
|
|
|
Note When the cellular interface requires a static IP address, the address may be configured as ip address negotiated. Through IP Control Protocol (IPCP), the network ensures that the correct static IP address is allocated to the device. If a tunnel interface is configured with the ip address unnumbered <cellular interface> command, the actual static IP address must be configured under the cellular interface, in place of ip address negotiated. For a sample cellular interface configuration, see the “Basic Cellular Interface Configuration” section on page
Configuring DDR
Perform these steps to configure
SUMMARY STEPS
1.configure terminal
2.interface cellular 0
3.dialer
4.dialer
5.dialer string string
6.dialer group number
7.exit
8.
9.ip
10.line 3
11.script dialer <regexp>
12.exit
13.
CONNECT or
CONNECT
14.interface cellular 0
15.dialer string <string>
|
| Cisco 819 Series Integrated Services Router Software Configuration Guide |
|
| |
|
|
| |||
|
|
|
| ||
|
|
|
|