SpeedStream Router User Guide
Note Depending on your configuration, NAT is sometimes enabled by default. Disable NAT only in advanced situations where your ISP has assigned static IP addresses.
2.To continue to the Connection Name window, click Next.
Specify Connection Name
1.On the Connection Name window, enter a name for the new connection.
2.To complete the configuration process for the PPPoE/Bridge Only protocol, click Next.
The VC Wizard window displays.
Finish
•On the VC Wizard window, click Finish.
The Current Configuration window displays the new connection information.
Configure PPPoE / 2684B
Connection
This mode concurrently runs PPPoE with a 2684 Bridge on the same virtual connection.
•On the PPPoE Type window, select 2684B Connection. The 2684 Bridged window displays
Enter IP Information
1.On the 2684 Bridged window, select to use DHCP or specify the IP information:
•Use DHCP:
If your service provider offers DHCP server, automatically obtains the IP address.
•Specify IP Information:
Enter IP address, subnet mask, default gateway (optional) and DNS server (optional).
2.To continue to the 2684 PPPoE window, click Next.
Select Interface Options
1.On the Interface Options window, select the desired options:
43
