Efficient Networks 5100 Series manual SpeedStream Router User Guide

		SpeedStream Router User Guide
5b. If you selected the PPPoE protocol and PPPoE / Bridged type:
Step	On this window:	Do this:
5b	Interface Options	Select interface options: firewall, attack detection system, universal plug
		and play; RIP; NAT/NAPT.
6	Connection Name	Enter name to use for this connection.
7	VC Wizard	Finish.
5c. If you selected the PPPoE protocol and 2684B Connection type:
Step	On this window:	Do this:
5c	2684 Bridged	Enter Internet protocol information as provided by your service provider.
6	Interface Options	Select interface options: firewall, attack detection system, universal plug
		and play; RIP; NAT/NAPT.
7	Connection Name	Enter name to use for this connection.
8	PPPoE Session Count	Specify the number (1-4) of PPP sessions you want to configure. For each
		session, steps 7-11 will repeat.
9	User Information	Enter user name and password (both are optional).
10	PPP Options	Select PPP options for this connection: dial-up mode, auto-connect on
		disconnect, idle timeout
11	PPP Static IP	Enter static IP address (optional).
12	Interface Options	Select interface options: firewall, attack detection system, universal plug
		and play; RIP; NAT/NAPT.
13	Connection Name	Enter name to use for this connection. If multiple sessions were selected,
		repeat steps 7-11 until last session is configured; then go to step 12.
14	VC Wizard	Finish.

5d. If you selected the PPPoE protocol and PPPoE Bridge type, and elected to have the virtual

connection also use 2684B Connection:

Note If you elected not to have the virtual connection also use 2684B Connection, steps 6, 7 and 8 are not relevant, and those windows will not display.

Step	On this window:	Do this:
5d	PPPoE with Bridge	Specify whether the virtual circuit (VC) should also use a 2684 Bridged
		connection.
6	2684 Bridged	Enter Internet Protocol information as provided by your service provider.
7	Interface Options	Select interface options: firewall, attack detection system, universal plug
		and play; RIP; NAT/NAPT.
8	Connection Name	Enter name to use for this connection.
9	PPPoE Session Count	Specify the number (1-4) of PPP sessions you want to configure. For each
		112