Efficient Networks 5100 Series manual VC Wizard Finish, Configuration procedures

SpeedStream Router User Guide

Step	On this window:	Do this:
8	VC Wizard	Finish.

4c. If you selected the RFC-2684 Routed protocol:

Step	On this window:	Do this:
4c	2684 Routed	Enter Internet Protocol information as provided by your service provider.
5	Interface Options	Select interface options: firewall, attack detection system, universal plug
		and play; RIP; NAT/NAPT.
6	Connection Name	Enter name to use for this connection.
7	VC Wizard	Finish.

4d. If you selected the PPPoE protocol:

Step	On this window:		Do this:
4d	PPPoE Type		Select PPPoE type: client, bridged, 2684 connection, or PPPoE bridge.
5	This step is dependent on your choice of protocol. Click the protocol type to jump to the specific
	configuration procedures.
	5a	PPPoE Client
	5b	PPPoE Bridge
	5c	PPPoE 2684B Connection
	5d	PPPoE with PPPoE Bridge

5a. If you selected the PPPoE protocol and Client type:

Step	On this window:	Do this:
5a	PPPoE Session Count	Specify the number (1-4) of PPP sessions you want to configure. For each
		session, steps 4-8 will repeat.
6	User Information	Enter user name and password (both are optional).
7	PPP Options	Select PPP options for this connection: dial-up mode, auto-connect on
		disconnect, idle timeout.
8	PPP Static IP	Enter static IP address (optional).
9	Interface Options	Select interface options: firewall, attack detection system, universal plug
		and play; RIP; NAT/NAPT.
10	Connection Name	Enter name to use for this connection. If multiple sessions were selected,
		repeat steps 4-8 until last session is configured; then go to step 6.
11	VC Wizard	Finish.

111