SpeedStream Router User Guide
Select Interface Options
1.On the Interface Options window, select the desired options:
•Use Firewall:
Enable firewall protection.
•Use Attack Detection System: Enable WAN attack protection.
•Use Universal Plug-n-Play:
Enable devices to discover and control each other via UPnP over the network.
•RIP:
Routing Information Protocol (For more information, see page 83.)
-Version 1:
Allows RIP version 1 to be transmitted/received on the selected interface. Currently, RIPv1 is seldom used, but supported on the SpeedStream router.
-Version 2:
Allows RIP version 2 to be transmitted/received on the selected interface. This would be the most common choice.
-Versions 1 & 2: Simultaneously supports RIP versions 1 and 2 on the selected interface.
-Active Mode:
In enabled, the router will receive routing updates on the selected
interface and will broadcast regular routing updates to other routers. If not enabled (default), the router will receive routing updates on this interface, but will not broadcast routing tables.
•NAT/NAPT:
Enable Network Address Translation (NAT) and/or Network Address Port Translation (NAPT). For more information on using NAT and NAPT, see page 65.
-Disabled:
Disable both NAT and NAPT (for example, if setting up static routes).
-NAT:
Enable NAT only and specify the destination IP address for incoming packets on the selected WAN interface.
-NAPT:
Enable NAPT only to handle multiple addresses based on port forwarding rules.
-NAT & NAPT:
Enable concurrent NAT and NAPT
42
