Chapter 8 Configuring the Serial Interface
How to Configure Serial Interfaces
Tuning Half-Duplex Timers
To optimize the performance of
Command |
| Purpose |
|
| |
Tunes | ||
| ||
| ||
| ||
|
| |
|
|
|
The timer tuning commands permit you to adjust the timing of the
Note that the
•sdlc cts-delay
•sdlc rts-timeout
Changing Between Synchronous and Asynchronous Modes
To specify the mode of a
SUMMARY STEPS
1.physical-layer {sync async}
DETAILED STEPS
| Command or Action | Purpose |
|
|
|
Step 1 | Specifies the mode of a | |
|
| synchronous or asynchronous. |
| Example: |
|
|
| |
|
|
|
This command applies only to
Note When you make a transition from asynchronous mode to synchronous mode in serial interfaces, the interface state becomes down by default. You should then use the no shutdown option to bring the interface up.
In synchronous mode,
•sdlc
•sdlc
| Cisco 819 Series Integrated Services Routers Software Configuration Guide |
|