Cisco Systems AIRCAP3502EAK9 specifications Pre-Installation Configuration Setup

Page 9

Pre-Installation Configuration Setup

Figure 3 shows the pre-installation configuration setup.

Figure 3 Pre-Installation Configuration Setup

Controller

Layer 3 devices

Cisco Aironet access points

272488

Follow these steps to perform the pre-installation configuration.

Step 1 Make sure that the Cisco wireless LAN controller DS port is connected to the network. Use the CLI, web-browser interface, or Cisco WCS procedures as described in the appropriate Cisco wireless LAN controller guide.

a.Make sure that access points have Layer 3 connectivity to the Cisco wireless LAN controller Management and AP-Manager Interface.

b.Configure the switch to which your access point is to attach. See the Cisco Unified Wireless Network WLAN Controller Guide: Cisco 440x Series WLAN Controllers for additional information.

c.Set the Cisco wireless LAN controller as the master so that new access points always join with it.

d.Make sure DHCP is enabled on the network. The access point must receive its IP address through DHCP.

9

Image 9
Contents Cisco Aironet 3502P Lightweight Access Point About this Guide Safety Instructions20A. Statement UnpackingOverview Access Point Ports and Connections topAccess Point Ports and Connections bottom Controller Discovery Process Configuring the Access PointPreparing the Access Point Performing a Pre-Installation Configuration Installation SummaryController Layer 3 devices Cisco Aironet access points Pre-Installation Configuration SetupPage Page Deploying the Access Point on the Wireless Network Mounting the Access PointUsing Dhcp Option TroubleshootingLED Checking the Access Point LEDLED Troubleshooting the Access Point Join Process Declarations of Conformity and Regulatory Information Models Vcci Statement for Japan English Translation Japanese TranslationStatement 371-Power Cable and AC Adapter Industry CanadaCanadian Compliance Statement Déclaration de conformité pour le Canada Page Page United States Declaration of Conformity for RF ExposureCanada European UnionAustralia Declaration of Conformity StatementsAdd the option 60 line using the following syntax Access Point SpecificationsCategory Specification Page USA