Cisco Systems AIRCAP3502EAK9 specifications Declaration of Conformity Statements, Australia

Page 26

Australia

This system has been evaluated for RF exposure for Humans as referenced in the Australian Radiation Protection standard and has been evaluated to the ICNIRP (International Commission on Non-Ionizing Radiation Protection) limits. The minimum separation distance from the antenna to general bystander is 20cm (7.9 inches). Installations utilizing antennas with gain greater than 10 dBi will assure a separation distance of at least 30 cm.

Declaration of Conformity Statements

All the Declaration of Conformity statements related to this product can be found at the following location: http://www.ciscofax.com

10Configuring DHCP Option 43 and DHCP Option 60

This section contains a DHCP Option 43 configuration example on a Windows 2003 Enterprise DHCP server for use with Cisco Aironet lightweight access points. For other DHCP server implementations, consult product documentation for configuring DHCP Option 43. In Option 43, you should use the IP address of the controller management interface.

Note DHCP Option 43 is limited to one access point type per DHCP pool. You must configure a separate DHCP pool for each access point type.

The 3502P access point uses the type-length-value (TLV) format for DHCP Option 43. DHCP servers must be programmed to return the option based on the access point’s DHCP Vendor Class Identifier (VCI) string (DHCP Option 60). The VCI string for the 3502P access point is:

Cisco AP c3502

The format of the TLV block is listed below:

•Type: 0xf1 (decimal 241)

•Length: Number of controller IP addresses * 4

•Value: List of WLC management interfaces

To configure DHCP Option 43 in the embedded Cisco IOS DHCP server, follow these steps:

Step 1 Enter configuration mode at the Cisco IOS CLI.

Step 2 Create the DHCP pool, including the necessary parameters such as default router and name server. A DHCP scope example is as follows:

ip dhcp pool <pool name>

26

Page 25 Page 27
Image 26
Page 25 Page 27
Contents Cisco Aironet 3502P Lightweight Access Point Safety Instructions About this GuideUnpacking 20A. StatementAccess Point Ports and Connections top OverviewAccess Point Ports and Connections bottom Configuring the Access Point Controller Discovery ProcessPreparing the Access Point Installation Summary Performing a Pre-Installation ConfigurationPre-Installation Configuration Setup Controller Layer 3 devices Cisco Aironet access pointsPage Page Mounting the Access Point Deploying the Access Point on the Wireless NetworkTroubleshooting Using Dhcp OptionChecking the Access Point LED LEDLED Troubleshooting the Access Point Join Process Declarations of Conformity and Regulatory Information Models Vcci Statement for Japan Japanese Translation English TranslationCanadian Compliance Statement Statement 371-Power Cable and AC AdapterIndustry Canada Déclaration de conformité pour le Canada Page Page Canada Declaration of Conformity for RF ExposureUnited States European UnionDeclaration of Conformity Statements AustraliaAccess Point Specifications Add the option 60 line using the following syntaxCategory Specification Page USA
Top Page Image Contents