Cisco Systems AIRCAP3702IAK9 specifications Pre-Installation Configuration Setup

Page 13

Pre-Installation Configuration Setup

The pre-installation configuration setup is shown in Figure 4.

Figure 4 Pre-Installation Configuration Setup

Controller

Layer 3 devices

Cisco Aironet access points

272488

To perform pre-installation configuration, perform the following steps:

Step 1 Make sure that the Cisco wireless LAN controller DS port is connected to the network. Use the CLI, web-browser interface, or Cisco WCS procedures as described in the appropriate Cisco wireless LAN controller guide.

a.Make sure that access points have Layer 3 connectivity to the Cisco wireless LAN controller Management and AP-Manager Interface.

b.Configure the switch to which your access point is to attach. See the Cisco Wireless LAN Controller Configuration Guide, Release x.x for additional information.

c.Set the Cisco wireless LAN controller as the master so that new access points always join with it.

d.Make sure DHCP is enabled on the network. The access point must receive its IP address through DHCP.

13

Image 13

Contents Cisco Aironet 3700 Series Access Points Created November, 2013 About this Guide Introduction to the Access PointImportant Safety Instructions Safety Instructions20A. Statement Unpacking ConfigurationsExternal Antennas Regulatory Domains Internal AntennasCountries Supported Access Point Ports and Connections top-3702E Model Access Point Ports and ConnectorsAccess Point LED Indicator top-3702I Model Controller Discovery Process Configuring the Access PointPreparing the Access Point Performing a Pre-Installation Configuration Installation SummaryController Layer 3 devices Cisco Aironet access points Pre-Installation Configuration SetupPage Deploying the Access Point on the Wireless Network Mounting the Access PointInstalling a Module Installing Modules345379 345380 Using Dhcp Option TroubleshootingChecking the Access Point LED LED LED Show ap join stats detailed ap base radio MAC address Troubleshooting the Access Point Join ProcessPage Declarations of Conformity and Regulatory Information Page Vcci Statement for Japan 03-6434-6500 Industry Canada Canadian Compliance Statement Statement 371-Power Cable and AC AdapterFrench Translation Access Point Models Page Page Generic Discussion on RF Exposure Declaration of Conformity for RF ExposureThis Device Meets FCC Guidelines for Exposure to Radio Waves Additional Information on RF Exposure Chinese Translation English Translation Portuguese Translation Operation of Cisco Aironet Access Points in BrazilDeclaration of Conformity Statements Configuring Dhcp Option 43 and Dhcp OptionType + Length + Value Category Specification Access Point SpecificationsPage Page Cisco Systems, Inc