Cisco Systems AIRCAP3702IAK9 specifications Mounting the Access Point

Page 15

Step 3 Configure the access point if required. Use the controller CLI, controller GUI, or Cisco Prime Infrastructure to customize the access-point-specific 802.11ac network settings.

Step 4 If the pre-installation configuration is successful, the Status LED is green indicating normal operation. Disconnect the access point and mount it at the location at which you intend to deploy it on the wireless network.

Step 5 If your access point does not indicate normal operation, turn it off and repeat the pre-installation configuration.

Note When you are installing a Layer 3 access point on a different subnet than the Cisco wireless LAN controller, be sure that a DHCP server is reachable from the subnet on which you will be installing the access point, and that the subnet has a route back to the Cisco wireless LAN controller. Also be sure that the route back to the Cisco wireless LAN controller has destination UDP ports 5246 and 5247 open for CAPWAP communications. Ensure that the route back to the primary, secondary, and tertiary wireless LAN controller allows IP packet fragments. Finally, be sure that if address translation is used, that the access point and the Cisco wireless LAN controller have

astatic 1-to-1 NAT to an outside address. (Port Address Translation is not supported.)

8Mounting the Access Point

Cisco Aironet 3702 series access points can be mounted in several configurations, including on a suspended ceiling, on a hard ceiling or wall, on an electrical or network box, and above a suspended ceiling. Click this URL to browse to complete access point mounting instructions:

http://www.cisco.com/en/US/docs/wireless/access_point/mounting/guide/apmount.html

9Deploying the Access Point on the Wireless Network

After you have mounted the access point, follow these steps to deploy it on the wireless network:

Step 1 Connect and power up the access point.

15

Page 14 Page 16
Image 15
Page 14 Page 16
Contents Cisco Aironet 3700 Series Access Points Created November, 2013 About this Guide Introduction to the Access PointImportant Safety Instructions Safety Instructions20A. Statement Configurations UnpackingExternal Antennas Internal Antennas Regulatory DomainsCountries Supported Access Point Ports and Connections top-3702E Model Access Point Ports and ConnectorsAccess Point LED Indicator top-3702I Model Controller Discovery Process Configuring the Access PointPreparing the Access Point Performing a Pre-Installation Configuration Installation SummaryController Layer 3 devices Cisco Aironet access points Pre-Installation Configuration SetupPage Deploying the Access Point on the Wireless Network Mounting the Access PointInstalling a Module Installing Modules345379 345380 Troubleshooting Using Dhcp OptionChecking the Access Point LED LED LED Show ap join stats detailed ap base radio MAC address Troubleshooting the Access Point Join ProcessPage Declarations of Conformity and Regulatory Information Page Vcci Statement for Japan 03-6434-6500 Industry Canada Canadian Compliance Statement Statement 371-Power Cable and AC AdapterFrench Translation Access Point Models Page Page Generic Discussion on RF Exposure Declaration of Conformity for RF ExposureThis Device Meets FCC Guidelines for Exposure to Radio Waves Additional Information on RF Exposure Chinese Translation English Translation Portuguese Translation Operation of Cisco Aironet Access Points in BrazilDeclaration of Conformity Statements Configuring Dhcp Option 43 and Dhcp OptionType + Length + Value Category Specification Access Point SpecificationsPage Page Cisco Systems, Inc
Top Page Image Contents