Tool settings, Switching the ma Chine on and off

Switching the ma-

chine on and off

Keep the machine steady during switching and during use by hold- ing the handles [3-1] [3-2] with both hands.

The switch [3-4] is an on/off switch (I = ON, 0 = OFF).

cool down for approx. 3-5 minutes before us- ing it again. The machine requires less time to cool down if it is running, i.e. in neutral position.

Changing the router table

The “large surface router table” is already ﬁt- ted as standard. The large contact surface and precision adjustment features of this router table enable a high degree of accuracy. Other

3-4

3-1

3-2

3-3

router tables are included in the accessories programme.

a) Large surface router table

4-1

Tool settings

Disconnect the plug from the power source before making any adjust- ments, changing accessories, or storing power tools.

Electronic control

The machine features full-wave electronics with the following properties:

Smooth start-up

The electronically controlled smooth start-up function ensures that the machine starts up smoothly.

Speed control

You can regulate the rotational speed steplessly between 10000 and 26000 rpm using the adjusting wheel [3-3]. This enables you to optimise the cutting speed to suit the respective material.

Constant speed

The preselected motor speed remains con- stant through electronic control. This ensures a uniform cutting speed even when under strain.

Temperature control

To prevent overheating, the safety electronics switches the machine off when it reaches a critical motor temperature. Let the machine

4-2

–Slide the router table onto the retaining pin [4-1] on the machine.

–Tighten the screw [4-2] to clamp the router table in position.

	4-5
5	4-4
5

4-3

–Place the extraction hood [4-4] in posi- tion.

–Tighten the screw [4-3] to clamp the ex- traction hood in position.

–Place the extractor connector [4-5] on the extraction hood.

Removal is performed in reverse sequence to installation.