Sanyo SPW-XR254EH56 Installing the Drain Piping, Tighten the hose clamps, Upward. Fig

2-4. Installing the Drain Piping

(1)Prepare standard hard PVC pipe for the drain and use the supplied drain hose and hose band to prevent water leaks.

The PVC pipe must be purchased separately.

The transparent part allows you to check drain- age. (Fig. 2-6)

	Tighten the hose clamps
CAUTION	so their locking nuts face
	upward. (Fig. 2-6)

(2)After checking the drainage, wrap the supplied packing and drain pipe insulator around the pipe. (Fig. 2-7)

NOTE

Transparent part for	Hose band	Hard PVC pipe
checking drainage	(supplied)	(not supplied)

Packing	Drain hose	Drain hose
		adapter
(supplied)	(supplied)	(supplied)

0964_X_I

Fig. 2-6

Drain insulator (supplied)

Ensure the drain pipe has a downward gradient (1/100 or more) and that there are no water traps.

	● Do not install an air
CAUTION	bleeder tubes, as this
	may cause water to spray
	from the drain tube outlet.
	(Fig. 2-8)

● If it is necessary to increase the height

of the drain pipe, the section directly

after the connection port can be raised

Fig. 2-7

Air bleeder

Fig. 2-8

0197_X_I

0047_X_I

a maximum of 50 cm. Do not raise it

any higher than 50 cm, as this could

result in water leaks.

(Fig. 2-9)

● Do not install the pipe with an upward

gradient from the connection port. It

will cause the drain water to flow

backwards and leak when the unit is

stopped. (Fig. 2-10)

● Do not apply force to the piping on the

unit side when connecting the drain

pipe. The pipe should not be allowed

to hang unsupported from its connec-

tion to the unit. Fasten the pipe to a

wall, frame, or other support as close

to the unit as possible. (Fig. 2-11)

● Provide insulation for any drain pipes

that are installed indoors.

30 cm or less (as short as possible)

50 cm or less

2262_X_I

Fig. 2-9

Upward gradient

0049_X_I

Fig. 2-10

Support pieces

0050_X_I

Fig. 2-11

7