Contour Sanding
Referring to Figure 19:
Contour sanding is done from the extension table mounted on the motor where the sanding belt wraps around the drive drum (D). To set up the sander for contour sanding:
1.Loosen the two lock knobs (C) that secure the drum guard & dust port (E).
2.Swing the end guard (E) back, bringing the drive drum (D) into view.
3.Tighten the lock knobs (C).
4.Mount the extension table (A) to the sander by inserting the post (B) into the bracket (F).
5.Set the table to the desired height, then secure into position by tightening the lock knob (G).
Important: When the extension table (B) is not in use, the drum guard & dust port (E) should always be in the closed position so the drive drum (D) is not in view.
Figure 19
16