Table of Contents |
|
Warranty and Service | 2 |
Table of Contents | 3 |
Warnings | 4 |
Introduction | 6 |
Specifications | 6 |
Unpacking | 7 |
Shipping Contents | 7 |
Tools Needed for Assembly | 7 |
Assembly | 8 |
Stand Assembly | 8 |
Installing Table and Motor Unit to Stand | 8 |
Sanding Belt Installation | 9 |
Drum Guard & Dust Port | 10 |
Extension Table | 10 |
Electrical | 11 |
Grounding Instructions | 11 |
115 Volt Operation | 11 |
230 Volt Operation | 11 |
Adjustments | 12 |
Sanding Platen Angle Adjustment | 12 |
Platen Lock Tension Adjustment | 12 |
Changing the Sanding Belt | 13 |
Belt Tracking Adjustment | 13 |
Motor Mount Tracking Adjustment | 14 |
Table Adjustment | 14 |
Basic Operations | 15 |
Horizontal Sanding | 15 |
Vertical Sanding | 15 |
Contour Sanding | 16 |
Troubleshooting Operating Problems | 17 |
Parts | 17 |
Ordering Replacement Parts | 17 |
Table and Motor – Parts | 18 |
Sanding Belts | 19 |
Table and Motor – Assembly | 20 |
Idle Drum – Parts | 21 |
Stand Assembly | 23 |
Wiring Diagram | 24 |
The specifications in this manual are given as general information and are not binding. WMH Tool Group reserves the right to effect, at any time and without prior notice, changes or alterations to parts, fittings, and accessory equipment deemed necessary for any reason whatsoever.
3