Assembly
Stand Assembly
Referring to Figure 1:
1.Remove all contents from the shipping container.
2.Clean all rust protected surfaces with a mild solvent. Do not use paint or lacquer thinner, gasoline, or mineral spirits; these will damage painted surfaces.
3.Attach the four rubber pads (A) to the bottoms of the side panels (C) with four each 5/16” x 5/8” screws, 5/16” flat washers and 5/16” hex nuts (B). The hardware can be found in the bag with the rubber pads.
4.Attach the side panels (C) to the front panel (D) with four 5/16” x 5/8” hex cap screws, eight 5/16” flat washers, four 5/16” lock washers, and four 5/16” hex nuts (E). Hand tighten the hardware at this point.
Note: Assemble the stand upside down to make sure that the tops of the panels are flush.
5.Mount the shelf (F) to the inside of the stand with two M5x10 pan head screws, two M5 flat washers and two M5 lock washers (G).
6.Finish the stand assembly by attaching the rear panel (H) to side panels (C) with four 5/16” x 5/8” hex cap screws, eight 5/16” flat washers, four 5/16” lock washers, and four 5/16” hex nuts (J).
7.Make sure stand is sitting evenly on a level surface before tightening hardware.
Installing Table and Motor Unit to Stand
The Table and Motor Unit is heavy! Use great care and adequate resources when lifting the unit up onto the stand! Failure to comply may cause serious injury and/or damage to the sander and/or property!
Referring to Figure 2:
1.With the aid of another person, carefully lift the table and motor unit (A) out of the shipping box, and up onto the stand (B).
2.Line up threaded holes in the base (C) with the holes in the stand (D).
3.Open the cabinet door (E) and through the opening attach main unit to stand with two 5/16” x
Figure 1
Figure 2
8