Contents of the Shipping Carton
1. Sander
1. Sanding Belt
1.Sanding Disc
2.Tables
1. Center Point
3. Handles
2. 5/16” Flat Washers
1. Miter Gauge
1. Owner's Manual
1. Warranty Card
Tools Required for Assembly
1. 13mm Wrench or socket (stand)
1. 12mm Wrench or socket (stand)
WARNING
Read and understandthe entire contents of this manual before attempting assembly or operation of the disc/belt sander!
Failure to comply may cause serious injury!
Unpacking
1. Remove all contents from the shipping carton.
2. Report any damage to your distributor.
3. Do not discard any shipping material until the sander has been assembled and is running properly.
Open Stand Assembly (Optional)
1. Match the hole patterns in the stand legs with the hole patterns in the stand top pieces. Mount the legs to the outside of the top pieces using sixteen 5/16”x5/8” carriage bolts and sixteen 5/16” lock nuts. Do not tighten until the stand has been assembled and is sitting level on the floor. Note: Flange of long top pieces overlap flange of short top pieces.
2. Install the leveling pads in the bottom hole of legs with eight 3/8” hex nuts and eight 3/8” flat washers.
3. Mount the belt rack to the stand by inserting the 90° bend through the stand and securing the rack in place with a 3/8”x3/4” hex cap bolt, two 3/8” flat washers and a 3/8” hex nut.
Closed Stand Assembly (Optional)
1.Mount the belt rack to the stand by inserting the 90° bend through the stand and securing the rack in place with a hex cap bolt, and a flat washer.
7