Horizontal Sanding Workstop
1.Loosen the socket head cap screw (A, Fig. 7) so that the sanding belt can be rotated to the horizontal position.
2.Rotate the sander until the stop (B, Fig. 7) contacts the sander base. Tighten the socket head cap screw.
3.When the sanding belt is used in the horizontal position, the table may be used as a workstop, as shown in Figure 7.
Sanding Belt Replacement
1.Disconnect the machine from the power source.
2.Remove the handle (A, Fig. 8).
3.Release two latches (B, Fig. 8) and open the doors.
4.Pivot the trunnion assembly (A, Fig. 9) out of the way.
5.Release the belt tension by moving the tension handle to the “Loosen” position.
6.Slide the belt off of both sanding drums.
7.Slide new 6”x48” belt sanding belt over both sanding drums, making sure the belt will travel in the direction of the arrow located on the inside of the belt.
8.
10