Mounting T26417 to
Bench
Anchoring T26418 to
Floor
The base of this machine has mounting holes that allow it to be fastened to a workbench or other mounting surface to prevent it from moving during operation and causing accidental injury or damage.
The strongest mounting option is a "Through Mount" (see example below) where holes are drilled all the way through the
Hex |
Bolt |
Flat Washer |
Machine Base |
Workbench |
Flat Washer |
Lock Washer |
Hex Nut |
Figure 7. Example of a "Through Mount" setup.
Another option is a "Direct Mount" (see example below) where the machine is secured directly to the workbench with lag screws and washers.
Lag Screw
Flat Washer
Machine Base
Workbench
Figure 8. Example of a "Direct Mount" setup.
Anchoring machinery to the floor prevents tipping or shifting and reduces vibration that may occur during operation, resulting in a machine that runs slightly quieter and feels more solid.
If the machine will be installed in a commercial or workplace setting, or if it is permanently connect- ed (hardwired) to the power supply, local codes may require that it be anchored to the floor.
If not required by any local codes, fastening the machine to the floor is an optional step. If you choose not to do this with your machine, we rec- ommend placing it on machine mounts, as these provide an easy method for leveling and they have vibration-absorbing pads.
Anchoring to Concrete Floors
Lag shield anchors with lag screws (see below) are a popular way to anchor machinery to a con- crete floor, because the anchors sit flush with the floor surface, making it easy to unbolt and move the machine later, if needed. However, anytime local codes apply, you MUST follow the anchoring methodology specified by the code.
| Lag Screw |
| Flat Washer |
Machine Base |
|
Concrete | Lag Shield Anchor |
| |
| Drilled Hole |