Changing Spindle Sanding Sleeve
1.DISCONNECT MACHINE FROM POWER!
2.Secure sanding spindle in the machine spin- dle or with a vice.
3. Remove sanding spindle hex nut and top washer (see Figure 14).
| Spindle | |
Sanding Drum | Hex Nut | |
Bottom Washer | Top | |
Washer | ||
| ||
Table |
| |
Insert | Sanding | |
| ||
Sanding | Sleeve | |
| ||
Spindle |
|
Figure 14. Assembly order.
4.Pull sanding drum and sleeve off of sanding spindle.
5.Pull sanding sleeve off of sanding drum.
6.Re-assemble new sanding sleeve and sand- ing drum.
Note: Sanding sleeve slides over sanding drum easier if done prior to placing drum over spindle.
7.Re-install sanding spindle assembly as illus- trated in Figure 14.
8.Screw sanding spindle assembly into machine spindle.
9.Tighten spindle hex nut until sanding drum places slight pressure on sanding sleeve.
Model T26417/T26418 (Mfd. Since 11/13) |