Grizzly T26417/T26418 owner manual Installing Sanding Drum/Sleeve, Installing Sanding Drums

Page 22

To complete a typical operation, the operator does the following:

1.Examines workpiece to make sure it is suit- able for sanding.

2.If necessary, tilts table to correct angle and locks it in place.

3. Install sanding drum assembly. (Refer to Installing Sanding Drum/Sleeve sub-sec- tion on this page.)

4.Selects table insert best suited to accommo- date size of the sanding drum and tilt of the table.

5.Puts on safety glasses and a respirator.

6.Starts oscillating sander.

7.Feeds workpiece against direction of spindle rotation, maintaining a safe working distance between hands and sanding drum.

8.Turns machine OFF.

Installing Sanding

Drum/Sleeve

Installing Sanding Drums

1.DISCONNECT MACHINE FROM POWER.

2.Thread the assembled sanding spindle, drum, and sleeve into the machine spindle.

3.Insert 22mm and 17mm wrenches through access panel beneath table (see Figure 13) and onto machine spindle and sanding spindle hex nuts. Tighten sanding spindle by turning counterclockwise when looking down on the spindle.

Sanding Spindle

Hex Nut

Machine Spindle

Hex Nut

Figure 13. Spindle hex nut.

4.To remove assembly, reverse Steps 2–3.

-20-	Model T26417/T26418 (Mfd. Since 11/13)

Image 22

Contents Oscillating Spindle Sander Page Table of Contents Introduction Contact Info Manual AccuracyIdentification Machine Data Sheet Construction Materials Machine Data Sheet Construction Materials Safety Safety Instructions for MachineryModel T26417/T26418 Mfd. Since 11/13 Additional Safety for Spindle Sanders Full-Load Current Rating Power SupplyAvailability 110V Circuit Requirements16 AWG Grounding & Plug RequirementsExtension Cords 14 AWGUnpacking SetupNeeded for Setup Description QtyInventory T26418 Inventory Box 2 Figure QtySite Considerations CleanupPlacement Location Workbench LoadWorkbench Mounting T26417 to Bench Anchoring T26418 to FloorAnchoring to Concrete Floors Machine Base WorkbenchAssembly Dust Collection To connect a dust collection hoseTest Run Operations Operation OverviewInstalling Sanding Drum/Sleeve Installing Sanding DrumsChanging Spindle Sanding Sleeve Tilting Table To tilt the tableT26417 Table InsertsSanding T26418Accessories Sanding Sleeve cleanersPack of hard sanding sleeves Schedule MaintenanceCleaning LubricationService TroubleshootingWiring Wiring Safety InstructionsT26417 Wiring Diagram T26417 switch connectionsT26418 Wiring Diagram T26418 switch connectionParts T26417 MainDescription T26417 Oscillator Assembly T26417 Machine Labels & Cosmetics T26418 Main Angle Rack T26418 Oscillator Assembly T26418 Machine Labels & Cosmetics Warranty Card CommentsGrizzly INDUSTRIAL, INC BOX BELLINGHAM, WAWarranty & Returns