Adjustments
Adjusting the Contact Arm and Handle
1.Loosen the cap screws shown in Figure 10.
Cap Screws
Figure 10. Sander adjustments.
2.Rotate the handle and contact arm to the desired position, then tighten the cap screws.
Note: By rotating the contact arm and handle, the Model H8253 can be adjusted for right or left hand use (Figure 11).
|
|
|
|
|
| Left Hand Use |
| Right Hand Use |
|
|
|
|
|
|
|
|
|
|
|
Figure 11. Left hand/right hand setup.
Adjusting the Belt Tracking
The sanding belt must be centered on the contact wheel to avoid damaging the sander and to allow for optimal sanding.
To adjust the belt tracking:
1.Connect the sander to compressed air regulated at 70-90 PSI.
2.Hold the sander firmly and press the throttle lever to turn it ON. Once the belt has reached full speed, turn the adjustment knob to adjust the belt tracking. Turning the knob clockwise will move the belt towards the adjusting knob and turning the knob counter- clockwise will move the belt away from the adjusting knob (Figures 12 & 13).
|
|
|
|
|
|
|
|
|
|
| Adjustment Knob | ||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| Figure 12. Belt tracking. | |||||
|
|
|
|
|
|
|
| Correct Belt |
|
|
| Incorrect Belt |
|
| Tracking |
|
|
| Tracking |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Figure 13. Belt tracking.
Model H8253 Air Belt Sander |