ASSEMBLY
The Model H8253 must be assembled before use. Assembly consists of connecting the contact arm assembly to the air motor and attaching the handle.
Connecting the Contact Arm
1.DO NOT YET CONNECT THE SANDER TO THE AIR SUPPLY!
2.Slide the contact arm assembly onto the air motor, making sure it is snug against the shoulder, as shown in Figure 3.
Cap Screw |
Air Motor |
Contact |
Arm |
Figure 3. Installing the contact arm.
3.Tighten the cap screw to secure the contact arm assembly to the air motor.
Note: The angle of the contact arm will later be adjusted to suit the user's pref- erence and specific sanding task per- formed. This procedure is discussed in Adjustments on Page 8.
Attaching the Handle
1.DO NOT YET CONNECT THE SANDER TO THE AIR SUPPLY!
2.Thread the handle into the handle arm, as shown in Figure 4.
Handle
Handle Arm
Figure 4. Attaching the handle.
3.Make sure the handle is tight enough to not come loose during operations.
Model H8253 Air Belt Sander |