OPERATIONS
Read the manual before operation. Become familiar with this tool, its safety instructions, and its operation before beginning any work. Serious personal injury may result if safety or operational information is not understood or followed.
Like all tools there is potential danger when operating this tool. Accidents are frequently caused by lack of familiarity or failure to pay attention. If normal safety precautions are overlooked or ignored, serious personal injury may occur.
Attaching Sandpaper
1.DISCONNECT THE SANDER FROM THE AIR SUPPLY!
2.Install the 1⁄4" NPT male
3.The sanding pad for the Model H8219 measures 61/2" X 31/2". New sandpaper sheets can be obtained by cutting down a single sheet or a piece from a roll. Cut at least 21/2" extra for the length to fasten it properly.
Note: Using sandpaper that is torn or is smaller than the sanding pad will cause excessive wear and damage your sander.
4.Attach the sandpaper by clamping it onto both ends of the sander with the paper clamps as, shown in Figure 2.
Paper Clamp |
Holding Spikes |
Figure 2. Attaching the sandpaper.
5.Firmly press the paper clamps until the holding spikes (Figure 2) push through the sandpaper.
Model H8219 Air Orbital Sander |