Grizzly G0565 instruction manual Clean Up, Rubber Feet, Dust Collection

Clean Up

The unpainted surfaces are coated with thin layer of grease to protect them from corrosion during shipment. Wipe off this protective coating with a clean dry rag and apply a solvent cleaner or citrus-based degreaser such as Grizzly’s G7895 Degreaser to remove any residue. To clean thor- oughly, some parts may need to be removed. For optimum performance from your machine, make sure you clean all moving parts that are coated. Avoid chlorine-based solvents as they may damage painted surfaces should they come in contact. Always follow the manufacturer’s instructions when using any type of cleaning product.

Rubber Feet

Components and Hardware Needed:	Qty
Rubber Feet	4
Hex Nut 3⁄8-16"	4
Lock Washer 3⁄8"	4
Flat Washer 3⁄8"	4
Tools Needed:	Qty
Socket or Open End Wrench 9⁄16"	1
4x4 Block	1
To install the rubber feet:

1.Place one side of the sponge sander on a block—such as a 2X4.

2.Slide the rubber feet through the holes in the flange of the cabinet and secure with a lock washer, flat washer, and a hex nut.

3.Lower the sander onto the feet and place the other side of the sponge sander on a block.

4.Place the remaining feet through the flange holes. Secure with hex nuts and washers.

Dust Collection
Components and Hardware Needed:	Qty
Dust Collection System	1
4" Dust Hose (length as needed)	2
4" Hose Clamp	4
Tools Needed:	Qty
Flat Head Screwdriver	1
To install the dust hoses:

1.Slide the hose clamps onto the dust hoses.

2.Slide the hoses onto the dust hoods and tighten the hose clamps.

3.Attach the hoses to a dust collector.

G0565 Adjustable Sponge Sander -11-