4.With an assistant to steady the sanding assembly on the forks, lift and move it into position over the cabinet stand so that the mounting holes line up (see Figures 10 & 11).
Conveyor Front
Roller Guard
Figure 10. Mounting bolts and conveyor front
roller guard (left side).
Mounting Bolts
Figure 11. Mounting bolts (right side).
-16-
5.Secure the sanding assembly to the cabinet stand with the four hex bolts and flat washers removed in Step 2.
6.Remove the four 10-24 x 3/8" cap screws and flat washers from the front of the conveyor, slide the conveyor front roller guard onto the conveyor, and secure it with the cap screws and flat washers (see Figure 10).
7.Open the sanding belt access door on the left side of the machine, and remove the red shipping brace securing the sanding drum and the conveyor assembly (see Figure 12).
Figure 12. Location of the shipping brace.
G0644 15" Open-End Wide Belt Sander
