11.Turn the conveyor ON and verify that it oper- ates correctly.
12.Turn the conveyor belt OFF, and remove the switch disabling key, as shown in Figure 16.
Figure 16. Removing switch key from conveyor
toggle switch.
13.Try to start the conveyor by flipping the toggle switch to the ON position.
—If the conveyor does not start, the switch disabling feature is working as designed.
—If the conveyor starts, immediately stop the machine. The switch disabling feature is not working correctly. This safety feature must work properly before proceeding with regular operations. Call Tech Support for help.
14.Press the Emergency Stop button to turn the sanding motor OFF, re-install the switch disabling key, and reset the Emergency Stop button.
15.Disconnect the compressed air from the sander and attempt to turn the sanding motor ON.
—If the machine does not start, the air pres- sure safety switch is working correctly.
—If the machine does start (with the air pres- sure disconnected), immediately discon- nect power to the machine. The air pres- sure safety switch is not working correctly. This safety feature must work properly before proceeding with the rest of the test run. Call Tech Support for help.
G0644 15" Open-End Wide Belt Sander
Recommended
Adjustments
For your convenience, the adjustments listed below have been performed at the factory and no further setup is required to operate your machine.
However, because of the many variables involved with shipping, some of these adjustments may need to be repeated to ensure optimum results. Keep this in mind as you start to use your new drum sander.
•Conveyor Belt Tensioning (Page 30).
•Conveyor Belt Tracking (Page 31).
•Gib Adjustment (Page 31).
•Sanding Drum & Conveyor Parallelism (Page 32).
•Air Pressure Safety Switch (Page 33).
•Depth Of Cut Safety Bar (Page 33).
•Pressure Rollers (Page 34).