Grizzly G0644 owner manual Replacing Conveyor Belt, To replace the conveyor belt

Replacing Conveyor

Belt

Contact Grizzly Customer Service at (800) 523- 4777 to obtain a replacement conveyor belt (Part Number P0644024).

To replace the conveyor belt:

1.DISCONNECT THE SANDER FROM POWER!

2.Use a 4mm hex wrench to remove the M4-.7 x 10 cap screws and flat washers securing the front and rear conveyor roller guards (see Figure 40), then remove the guards.

Sanding Assembly
Mounting Brackets
& Hex Bolts
Rear Conveyor	Front Conveyor
Roller Guard	Roller Guard

Figure 40. Conveyor roller guards and sanding

assembly mounting brackets.

3.Use a 10mm wrench to loosen the con- veyor adjusting jam nuts (left and right), then release the tension on the conveyor belt by loosening the tension adjusting hex bolts (see Figure 41).

Tension

Adjusting

Hex Bolt

Jam Nut

Front Roller

Bracket

Button Head

Cap Screws

Figure 41. Conveyor belt tensioning fasteners

and front roller bracket.

4.Use a 5mm hex wrench to remove the three M8-1.25 x 18 button head cap screws secur- ing the left front conveyor roller bracket (see Figure 41), then, while supporting the front conveyor roller assembly, remove the brack- et.

5.Carefully pull the front conveyor roller assem- bly from the conveyor belt and the right front roller bracket.

NOTICE

Take care not to scratch or dent the front conveyor roller as you remove it from the sander. Damage to the conveyor roller could result in premature wear of the conveyor belt.

-36- G0644 15" Open-End Wide Belt Sander