Jet Tools 22-44 Plus owner manual

5.Wrap abrasive strip around the drum, being careful not to overlap the windings, see Figure 9.

6.Mark trailing end of strip where it crosses the inboard end of drum (A, Fig. 10).

7.Remove the abrasive strip and cut a taper as was done with the starting edge, see Figure 7. Note: The taper on the remaining roll can be used as the taper for the starting edge of the next strip to be cut.

8.Rewrap the drum starting at the left side as described in steps 3-5 on the previous page.

9.Raise fastener lever completely on the inboard end of drum, and insert the tapered end of abrasive strip through the slot into the take-up fastener.

Important: Position the abrasive strip with sufficient room between the inside of slot and the tapered end of strip to allow it to be pulled into the drum as needed, see Figure 11.

The abrasive strip may stretch enough in use to allow the take-up fastener to reach its lowest position so it no longer is able to maintain tension of the strip. If this occurs, it will be necessary to reset the take-up lever by raising it, pushing the strip end into the slot, and then releasing the clip lever.

The Tuf Tool (B, Fig. 12) can also be used to hold the take-up fastener in place while you feed the sandpaper through the slot. Hold the Tuf Tool at an angle to insert the end into the hole in take-up fastener. Pull the tool up and rotate 90° to clamp onto the drum, see Figure 12.

11