Specifications |
|
Stock Number | 649003K |
Max. Width (in) | 44 (two passes) |
Min. Length (in) | |
Max. Thickness (in) | 4 |
Min. Thickness (in) | 1/32 |
Drum (in) | 5x22 Extrusion, Aluminum |
Drum Speed (RPM) | 1700 |
Dust Chute (in) | 4 |
Conveyor Motor | 43 |
Conveyor Variable Feed Rate (FPM) | |
Motor (TEFC) | |
Net Weight (lbs) | 231 |
Shipping Weight (lbs) | 254 |
Table of Contents |
|
Warranty | 2 |
Warnings | |
Grounding Instructions | 5 |
115 Volt Operation | 5 |
Specifications | 6 |
Table of Contents | 6 |
Contents of the Shipping Carton | 7 |
Tools Required for Assembly & Adjustments | 7 |
Unpacking | 7 |
Assembly and Setup | 8 |
Drum Height Control | 8 |
Conveyor Belt Tension | 8 |
Conveyor Belt Tracking | 9 |
Dust Cover | 9 |
Checking Drum Alignment | 9 |
Aligning the Drum | 9 |
Fine Tuning Drum Alignment | 10 |
Wrapping Abrasive Strips | |
Connecting Sander to a Dust Collector | 12 |
Depth Gauge | 12 |
Setting the Depth of Cut | 12 |
Establishing the proper Drum Height | 12 |
Selecting SANDSMART™ Feed Rates | 13 |
Abrasives | 13 |
Selecting Drum Abrasives | 13 |
Selecting Abrasive Grits | 14 |
Stock Feeding Angle | 14 |
Multiple Piece Sanding Runs | 14 |
Edge Sanding | 14 |
Sanding Imperfect Stock | 14 |
Face Frames and Raised Panel Doors | 14 |
Monthly Maintenance | 14 |
Cleaning the Abrasive Strip | 15 |
Stretching Abrasive Life | 15 |
Conveyor Belt Replacement | 16 |
Tension Roller Alignment | 16 |
Tension Roller Pressure Adjustment | 16 |
Drum Height Control Adjustment | 16 |
Troubleshooting | 17 |
Part’s Breakdown and Part’s List | |
Wiring Diagram | 23 |
The specifications in this manual are given as general information and are not binding. The WMH Tool Group reserves the right to effect, at any time and without prior notice, changes or alterations to parts, fittings, and accessory equipment deemed necessary for any reason whatsoever.
6