Jet Tools 22-44 Plus owner manual Conveyor Belt Replacement, Tension Roller Alignment

Page 16

Conveyor Belt Replacement

To replace the conveyor belt:

1.Disconnect the machine from the power source. Unplug motor cord from control box.

2.Raise drum to highest position using the handwheel (A, Fig. 16).

3.Remove the belt tension by loosening the take-up nuts (B, Fig. 16).

4.Unscrew the four socket head cap screws (C, Fig. 16) that attach the conveyor and remove the conveyor from the bed.

5.Slide the conveyor belt off of the conveyor and replace with a new belt.

Tension Roller Alignment

1.Remove abrasive strip (D, Fig. 17) from drum.

2.Loosen all four bearing hex nuts (E, Fig. 17).

3.This will allow the tension rollers to drop to the lowest position.

4.Lower the sanding drum so it just touches the conveyor bed.

5.Turn the drum height handle one complete revolution to raise the drum.

6.Retighten bearing hex nuts.

Tension Roller Pressure Adjustment

You can also adjust the spring loaded screws, found on the pressure roller brackets, to increase or decrease roller pressure. If you are having snipe marks at the leading end of the board adjust the outfeed roller pressure. If the snipe mark occurs on the trailing end of the board adjust infeed roller pressure.

Drum Height Control Adjustment

If the height control mechanism does not operate easily or smoothly, or there is excessive vertical movement or deflection of the drum carriage, perform the following adjustments.

1.Tighten all four lock nuts (F, Fig. 18) and then loosen 1/8 to 1/4 turn.

2.Thoroughly lubricate the mating surfaces and height adjustment screw.

16

Image 16
Contents Plus Drum Sander Warranty & Service Volts Total Length of Cord in Feet AWGPage Grounding Instructions Volt OperationSpecifications Plus Drum Sander Table of ContentsContents of the Shipping Cartons Tools Required for Assembly & AdjustmentsDrum Height Control Assembly and SetupConveyor Belt Tension Conveyor Belt Tracking Dust CoverChecking Drum Alignment Aligning the DrumFine Tuning Drum Alignment Wrapping Abrasive StripsPage Connecting Sander to a Dust Collector Setting the Depth of CutDepth Gauge Establishing the Proper Drum HeightSelecting Sandsmart Feed Rates AbrasivesSelecting Drum Abrasives Grit Common ApplicationMonthly Maintenance Selecting Abrasive GritsStock Feeding Angle Multiple-Piece Sanding RunsStretching Abrasive Life Cleaning Abrasive StripsPerformax 22-44 Abrasives Conveyor Belt Replacement Tension Roller Pressure AdjustmentDrum Height Control Adjustment Tension Roller AlignmentTroubleshooting Guide Problem Possible Cause SolutionDrum Head Assembly Index Part Description Size Qty 12-2000-04 Conveyor And Motor Assembly 323759 Wiring Diagram