B. | PERSONAL PRECAUTIONS AND SAFETY |
1.WARNING: Wear complete eye protection and protective clothing, when working with
2.Make sure someone is within range of your voice or close enough to come to your aid when you work with or near a
3.Have plenty of fresh water and soap nearby for use if bat- tery acid contacts skin, clothing, or eyes. If battery acid con- tacts skin or clothing, wash immediately with soap and wa- ter.
4.Avoid touching your eyes while working with a battery. Acid particles (corrosion) may get into your eyes! If acid enters your eye, immediately flood eye with running cold water for at least 10 minutes. Get medical attention immediately.
5.Remove all personal metal items such as rings, bracelets, necklaces and watches when working with a
6.Take care not to drop a metal tool or other metal onto the battery. Metal may cause sparking or
7.Always operate battery charger in an open well ventilated area.
8.NEVER smoke or allow a spark or flame in the vicinity of the battery or engine. Batteries generate explosive gases!
C. | PREPARING TO CHARGE |
1.Make sure you have a 6 or 12 Volt
2.Clean battery terminals. Take care to keep corrosion from coming in contact with your eyes.
3.If required, add distilled water in each cell until battery acid reaches levels specified by battery manufacturer. This helps purge excessive gas from cells. Do not overfill. For a battery without cell caps, carefully follow manufacturer's recharg- ing instructions.
4.Study all battery manufacturer's specific precautions, such as removing or not removing cell caps while charging, and recommended rates of charge.
5.Make sure area around battery is well ventilated while bat- tery is being charged. Gas can be forcefully blown away by using a piece of cardboard or other
6.If necessary to remove battery from vehicle to charge, al- ways remove grounded terminal from battery first. Make sure all accessories in the vehicle are off, so as not to cause an arc.
7.A marine (boat) battery must be removed and charged on shore. To charge it on board requires equipment specially designed for marine use.
8.Select charge rate suitable for the battery being charged - (2, 10, or 15 Amp).
GROUNDING AND AC POWER CORD CONNECTION IN-
STRUCTIONS - Charger should be grounded to reduce risk of electric shock. Charger is equipped with an electric cord having an
DANGER - Never alter AC cord or plug provided. If it will not fit outlet, have proper outlet installed by a qualified electrician. Im- proper connection can result in a risk of electric shock.
This battery charger is for use on a nominal 120 Volt circuit, and has a grounding plug that looks like the plug illustrated in sketch
A.
During operation do not place the charger or its cables on the vehicle seat or carpeting.
When charging a battery in a motor home or RV always connect one lead of the output cable to the battery. Never connect to a remote receptacle or other means for the purpose of remotely charging the battery. The wires may be inadequate for handling the charge current of this charger and may over heat. Often these wires are bundled in with other wires which could be damaged and lead to a direct short across the battery and charger. If this occurs a fire can result, equipment and appliances operated from the battery may also be damaged.
GROUNDING METHOD
2