MOUNTING INSTRUCTION
Figure 1 illustrates the charger mounting brackets.
Figure 2 illustrates surface mounting of the charger to the fender well. If using the nut and bolt provided, drill two holes between 3/16" and 1/4" in diameter. (For alignment of holes use one of the brackets as a template.) If the backside of the mounting surface is hard to reach, you may consider using two 1/2" sheet- metal screws instead of nut bolt, drill a pilot hole if required, drill
holes between 1/8" and 5/32". CAUTION: Do not drill or punc-Figure 1 ture battery.
Electrical installations - Route and secure supply cord and out- put wiring away from gas line, carburetor or other hot, sharp or moving and pinch parts to avoid damage to the insulation. Se-
cure the AC cord and plug to a cable or from using a self lockingFigure 2 cable tie or equivalent.
Figure No. 3 illustrates mounting of the charger alongside the battery of your automobile. If convenient place the charger to the side of the battery away from the engine and fan blades, assemble the brackets as shown in figure No. 4. Loosen the battery retaining hardware enough that you can insert the longer portion of bracket "C" between the bottom of the battery and the battery mounting tray. Align the charger to freely stand without restrictions, then tighten all hardware.
FENDER WELL
12VOLT BATTERY
ELECTRICAL CONNECTION
The output leads of the charger are terminated with 3/8 inch ring lugs. Remove the bolts from the battery post connector, insert the bolt through the ring lug then place the bolt back in the battery connector and tighten. Connect the red lead to the positive (+) battery post and the black lead to the negative
If you have difficulty connecting the output leads, consult your local auto supply store, they may assist you in finding a con- necting device for your application.
Figure 4
Figure 3
| Figure 5 | |
| ||
LIMITED WARRANTY | ||
SCHUMACHER ELECTRIC CORPORATION, 801 BUSINESS CENTER DRIVE, | THIS IS THE ONLY EXPRESS LIMITED WARRANTY AND THE MANUFAC- | |
MOUNT PROSPECT, ILLINOIS | TURER NEITHER ASSUMES NOR AUTHORIZES ANYONE TO ASSUME OR | |
TO THE ORIGINAL PURCHASER AT RETAIL OF THIS PRODUCT. THIS LIM- | MAKE ANY OTHER OBLIGATION TOWARDS THE PRODUCT OTHER THAN | |
ITED WARRANTY IS NOT TRANSFERABLE. | THIS EXPRESS LIMITED WARRANTY. THE MANUFACTURER MAKES NO | |
Schumacher Electric Corporation warrants this battery charger for two years | WARRANTY OF MERCHANTABILITY OR FITNESS FOR PURPOSE OF THIS | |
PRODUCT AND EXPRESSLY EXCLUDES SUCH FROM THIS LIMITED WAR- | ||
from date of purchase at retail against defective material or workmanship. If | ||
RANTY. | ||
such should occur, the unit will be repaired or replaced at the option of the manu- | ||
| ||
facturer. It is the obligation of the purchaser to forward the unit together with | SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF INCI- | |
proof of purchase, transportation and/or mailing charges prepaid to the manu- | DENTAL OR CONSEQUENTIAL DAMAGES OR LENGTH OF IMPLIED WAR- | |
facturer or its authorized representative. | RANTY SO THE ABOVE LIMITATIONS OR EXCLUSIONS MAY NOT APPLY TO | |
This limited warranty is void if the product is misused, subjected to careless | YOU. | |
| ||
handling, or repaired by anyone other than the manufacturer or its authorized | THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS AND YOU MAYALSO | |
representative. | HAVE OTHER RIGHTS WHICH VARY FROM STATE TO STATE. | |
The manufacturer makes no warranty other than this limited warranty and ex- pressly excludes any implied warranty including any warranty for consequential damages.
3