REMOVING / ATTACHING BATTERY PACK
REMOVE BATTERY PACK:
1. Press both release buttons on either side of the Cordless Reciprocating Saw to release the battery pack.
2. Pull battery pack free of | RELEASE |
Cordless Reciprocating Saw. | |
| BUTTON |
ATTACH BATTERY PACK:
1. Align the raised portion of the battery |
pack with the groove in the battery com- |
partment of the Cordless Reciprocating Saw. |
CHARGE BATTERY PACK:
1.Plug the charger into the nearest 120 volt electrical outlet.
2.Make sure the trigger on the Cordless Reciprocating Saw is in the “OFF” position and remove the battery pack from the Cordless Reciprocating Saw.
CHARGING BATTERY PACK
BATTERY PACK
LED
LIGHT
2. Press the battery pack into place. Make sure the latches are securely fastened. Do |
not use the Cordless Reciprocating Saw if the battery pack is not seated properly. |
CHARGER
Before using battery charger, please read carefully all instructions and cautionary markings on battery charger, battery pack and product using battery.
Use only the charger which accompanied your product or direct replacement as listed in this manual. Do not substitute any other charger. Use only Alltrade approved chargers with your product.
Do not disassemble charger.
Do not use charger if it has been damaged, left outdoors in the rain, snow, wet or damp environments, or immersed in liquid.
The battery pack and charger heat during charging. Place the charger on a flat,
When the battery pack requires recharging, a 1 hour charge allows the tool to operate at full power. A charging indicator light on the charger will illuminate to show that charging is taking place.
3.Insert the battery pack
into the charger. Be sure that the battery pack is fully seated in the charger. Do not force.
4.The red indicator light should come “ON” indicating that the battery pack is in a “Fast Charge” mode. If the green indicator light comes “ON”, then the battery is already fully charged.
5.After approximately one hour of charging, the red indicator light should go “OFF” and the green light should come “ON” indicating that the battery is fully charged and the charger is now in a “Trickle Charge” mode.
6.The battery can be left in a “Trickle Charge” mode until ready to use.
IMPORTANT INFORMATION FOR RECHARGING HOT BATTERIES
When using your Cordless Reciprocating Saw continuously, the batteries in your battery pack will become hot. You should let a hot battery pack cool down for approximately 30 minutes before attempting to recharge. When the battery pack becomes discharged and is hot, the red light on the charger will flash. When the battery pack cools down, the red light will glow continuously to indicate fast charging mode,
This will occur when continuous use of your Cordless Reciprocating Saw causes the battery pack to become hot. It does not occur
under normal circumstances.
11 | 12 |