When using the Cordless Reciprocating Saw, always maintain a firm grip on
the tool with both hands. Never put your hands or feet in the cutting area. Do not grasp the tool or place your hands too close to the blade. Keep your hands well away from the blade. Never reach underneath the tool while the blade is in motion. Do not use your legs or feet to stabilize the work piece.
Position yourself to avoid being caught between the tool or side handle and
walls or posts. Should the blade become bound or jammed in the work, it could result in loss of control and injury.
Do not run the Cordless Reciprocating Saw while carrying it at your side. A mov-
ing blade could cause serious personal injury.
Disconnect battery pack from tool and place the switch in the locked or “OFF” position before making any assembly, adjustments, changing acces- sories, performing any inspection, maintenance or cleaning procedures. Such
preventive safety measures reduce the risk of starting the tool accidentally which could cause serious personal injury.
Do not use the Cordless Reciprocating Saw if it has been damaged, left out- doors in the rain, snow, wet or damp environments, or immersed in liquid.
Do not use dull or damaged blades.
Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting edges are less likely to bind and are easier to control.
When restarting a saw in the workpiece, check that teeth are not engaged in the material.
Keep the handle of the Cordless Reciprocating Saw dry, clean, and free from oil and grease.
Be extra careful when cutting in high or
lookout for hidden wires and falling debris.
Maintain labels and nameplates on the Cordless Reciprocating Saw. These carry important information. If unreadable or missing, contact Alltrade for a replacement.
SYMBOLS
IMPORTANT: Some of the following symbols may be used on your tool. Please study them and learn their meaning. Proper interpretation of these symbols will allow you to operate the tool better and safer.
SYMBOL | NAME | EXPLANATION | |||||
|
| V | Volts | Voltage (Potential) | |||
|
| A | Amperes | Current | |||
| Hz | Hertz | Frequency (Cycles per Second) | ||||
| W | Watt | Power | ||||
| Kg | Kilograms | Weight | ||||
|
|
|
|
|
| Alternating Current | Type of Current |
|
|
|
|
|
| Direct Current | Type of Current |
|
|
|
|
|
| ||
|
|
|
|
|
| Alternating or Direct Current | Type of Current |
|
|
|
|
|
| Earthing Terminal | Grounding Terminal |
|
|
|
|
|
| ||
|
|
|
|
|
| Class II Construction | Denotes Double Insulation |
SYMBOL | NAME | EXPLANATION | |||||
| min | Minutes | Time | ||||
|
| s | Seconds | Time | |||
|
|
|
|
|
| Diameter | Size of Drill Bits, |
|
|
|
|
|
|
| Grinding Wheels, etc. |
|
|
|
|
|
| No load speed | |
.../min | Revolutions per Minute | Revolutions, Surface Speed, | |||||
|
|
|
|
|
|
| Strokes, etc. per Minute |
1,2,3, … | Ring Selector Settings | Speed, Torque or Position Settings | |||||
7 | 8 |