Harbor Freight Tools 95004 operating instructions Basic Operating Instructions

Page 15

 

BASIC OPERATING INSTRUCTIONS

1.

CAUTION! Always use safety equipment. Wear ANSI approved

 

safety impact eye goggles and heavy duty work gloves when oper-

 

ating the Jigsaw. Also, a dust mask and hearing protection must be

 

used for appropriate conditions.

2.IMPORTANT: Always secure the workpiece in place, using a vise or clamps (not included).

3.Make sure the Power Switch (67) is in its “OFF” position and the Power Cord/ Plug (68) is unplugged from the electrical outlet.

4.If necessary, make adjustments to the depth of cut and angle of cut.

5.Once all adjustments are made, plug the Power Cord/Plug (68) into the nearest 120 volt, grounded, electrical outlet.

6.Position the Saw Blade (20) about 1/2” from the beginning cut line on the workpiece. Do not allow the Saw Blade to come in contact with the workpiece.

7.Turn the Laser Switch (74) to its “ON” position, and align the laser beam with the cut line on the workpiece. Note: Kerf will be centered on laser beam.

8.Squeeze the Power Switch (67) to turn on the Circular Saw. If operating the Saw for an extended period of time, you may wish to depress the Switch Lock to lock the Power Switch in its “ON” position.

9.Allow the Saw Blade (20) to rotate at full speed before slowly feeding it into the workpiece.

10.Make sure to hold the Circular Saw firmly with both hands to avoid kickback. Then, finish making the cut.

11.When finished, release the Power Switch (67) to stop the Circular Saw. Wait until the Saw Blade (20) stops completely. Turn the Laser Switch (74) to its “OFF” position. Then, remove the Circular Saw from the workpiece.

12.Make sure to store the Circular Saw in a clean, dry, safe location out of reach of children and other unauthorized people.

SKU 95004

For technical questions, please call 1-800-444-3353

PAGE 15

Image 15
Contents For technical questions, please call 4 Circular SAWWork Area Product SpecificationsGeneral Safety Rules Save this ManualPersonal Safety Electrical SafetyTool USE and Care Service Specific Safety RulesPage Push the Saw Blade past the workpiece prior to release Kickback PrecautionsGrounded Tools Tools with Three Prong Plugs GroundingFigure a Double Insulated Tools Tools with TWO Prong Plugs See Figure C Extension CordsSymbology Product FeaturesUnpacking Assembly Instructions See Figure ESee Figure F To Adjust The Depth Of Cut Figure H See Figure HBasic Operating Instructions INSPECTION, MAINTENANCE, and Cleaning TroubleshootingSee Assy. Diagram See Assy. Diagram SKU For technical questions, please callSee Figure J Please Read the Following Carefully Parts ListAssembly Diagram Warranty Limited 90 DAY/1 Year Warranty