charged “AAA” Batteries, making sure to match the poles (+ and
(See Figure J.)
“AAA”BATTERIES
(QTY. 2)
FIGURE J
5.To clean or replace the Carbon Brushes (60): It may become necessary at sometime to clean or replace the two Carbon Brushes when the Motor perfor- mance decreases, or stops working completely. The Carbon Brushes are located on each side of the Housing (57). (See Assy. Diagram.)
A.Unscrew and remove the two Carbon Brush Covers (61) located on each side of the Housing (57). (See Assy. Diagram.)
B.Remove the two Carbon Brushes (60) from the two Brush Holders (59).
(See Assy. Diagram.)
C.If the Carbon Brushes (60) are worn down more than 1/2, replace both Carbon Brushes. If, however, the Carbon Brushes are just dirty they may be cleaned by rubbing them with a pencil eraser. Note: Reinstall in the same position/orientation that they were in before being removed.
(See Assy. Diagram.)
D.When installing the Carbon Brushes (60), make sure the carbon portion of the Carbon Brushes contact the motor’s Stator (56) and that the springs face away from the Stator. Also, make sure the springs operate freely.
(See Assy. Diagram.)
E.After replacement or cleaning, replace the two Carbon Brush Covers (61).
(See Assy. Diagram.)
F.NOTE: New Carbon Brushes (60) tend to arc or spark when first used until they wear and conform to the motor’s Stator (56). (See Assy. Diagram.)
SKU 95004 | For technical questions, please call | PAGE 17 |