Installing the universalshank jig saw blade
CAUTION:
Always be sure that the tool is switched off and battery removed before installing or removing the blade.
If the universal blade clamp is used, you can use blades of other makes which have a universal shank like the one shown in the figure, with a blade width of 6.35 mm
(1/4" 1.
Insert the blade into the blade holder as far as it will go. Make sure that the end of the blade shank reaches the bottom of the inner slit and tighten the bolt securely with the hex wrench.
Selecting the cutting action
This tool can be operated with an orbital or
astraight line cutting action. To change the cutting action, just turn the lever to the desired cutting action position. Refer to the table below to help determine the appro- priate cutting action.
Position
0
I I
II
1
1
1
Cutting action
Straight line cutting action
Small orbit cutting action
Medium Orbit cutting action
I
I
Applications
For cutting mild steel, stainless steel and plastics. For clean cuts in wood and plywood.
For cutting mild steel, aluminum and hard wood.
For cutting wood and plywood.
For fast cutting in aluminum and mild steel.
I
I
1 | 111 | I Large orbit cutting action | 1 For fast cutting in wood and plywood. | I |
9