Position 0 - For cutting in soft steel, stainless steel and plastics. For clean cuts in wood and plywood.
Position I - For cutting in soft steel, aluminum and hard wood.
Position I1 - For cutting in wood and plywood.
For fast cutting in aluminum and soft steel. Position 111 - For fast cutting in wood and plywood.
Switch action
Tool speed is increased by increasing pres- sure on the trigger. To start the tool, simply pull the trigger. Release the trigger to stop. For continuous operation, pull the trigger and then push in the lock button. To stop the tool from the locked position, pull the trigger fully, then release it. A speed control screw is provided so that maximum tool speed can be limited (vari- able). Turn the speed control screw clock- wise for higher speed, and counterclock- wise for lower speed.
CAUTION :
Lock button
Before plugging in the tool, always check to see that the trigger switch actuates properly and returns to the "OFF" position when released.
Operation
Turn the tool on and wait until the blade attains full speed. Then rest the base f l a t on the workpiece and gently move the tool forward along the previously marked cut- ting line. When cutting curves, advance the tool very slowly.
CAUTION :
Failure to hold the tool base flush with the workpiece may cause blade breakage.
7