Functional Description

CAUTION:

•Always be sure that the tool is switched off and the battery cartridge is removed before adjusting or checking function on the tool.

002481

1.Set plate

2.Battery cartridge

Installing or removing battery cartridge

•Always switch off the tool before insertion or removal of the battery cartridge.

•To remove the battery cartridge, pull out the set plate on the tool and grasp both sides of the cartridge while withdrawing it from the tool.

•To insert the battery cartridge, align the tongue on the battery cartridge with the groove in the housing and slip it into place. Snap the set plate back into place. Be sure to close the set plate fully before using the tool to prevent the battery cartridge from accidentally falling out of the tool.

•Do not use force when inserting the battery cartridge. If the cartridge does not slide in easily, it is not being inserted correctly.

001332

1. Charging light

Charging

1.Plug the battery charger into the proper AC voltage source.

2.Insert the battery cartridge so that the plus and minus terminals on the battery cartridge are on the same sides as their respective markings on the charger. Insert the cartridge fully into the port so that it rests on the charger port floor.

3.When the battery cartridge is inserted, the charging light color will flash in red color and charging will begin.

4.When the charging light goes out after about one hour, you may remove the fully charged battery cartridge.

5.After charging, unplug the charger from the power source.

NOTE:

•The battery charger is for charging Makita battery cartridge. Never use it for other purposes or for other manufacturer’s batteries.