Extron electronic IN1404XT manual Installation, cont’d, Standard output connections

Installation, cont’d

RGBHV

RGBS

RGsB,

Component

S-video

Composite

video

Cr	Y	Cb
R	G/Gs	B	H/S	V
Cr	Y	Cb
R	G/Gs	B	H/S	V
Cr	Y	Cb
(R-y)	Y	(B-Y)
(Pr)	Y	(Pb)
R	G/Gs	B	H/S	V
Cr	Y	Cb
(C)
R	G/Gs	B	H/S	V
Cr	Y	Cb
	(Vid)
R	G/Gs	B	H/S	V

Figure 2-3 — Connections for various input video formats

The audio bass, treble, and balance levels for each input can be individually set via the front panel or the RS-232 link. See chapter 3, Operation, and chapter 4, Programmer’s Guide for details.

Standard output connections

The two standard outputs, consisting of five BNC connectors and a 15HD connector, output the identical video signal and the same sync format.

5Output BNC connectors— Connect an RGBHV, RGBS, or RGsB video display to these female BNC connectors. Figure 2-4 shows how to connect the various video formats.

	RGBHV		H/S	V
		R	G/Gs	B
RGBS	H/S	V	RGsB		H/S	V
R	G/Gs	B		R	G/Gs	B

Figure 2-4 — BNC output connections for RGBHV and RGBS video

6Output 15HD connector — Connect an RGBHV, RGBS, or RGsB video display to this female 15HD connector.

The two standard output connectors, BNCs and 15-pin HD, are individually buffered (even when input 4 is configured as passive (unscaled). They can both be simultaneously connected and transmitted up to 100 feet on high quality coax cable without degradation of either output.

7Output audio connectors— Connect an audio device, such as an amplifier or powered speakers, to these left and right RCA connectors.

By default, the audio output follows the video switch. Audio breakaway, commanded via the RS-232 link, allows you to select from any one of the audio input sources. See chapter 3, Operation and chapter 4, Programmer’s Guide for details.

TP video output connection

RJ-45 termination must comply with the TIA/EIA T 568A or TIA/EIA T 568B wiring standards for all connections.

2-4 IN1404XT Video Scaler and Switcher • Installation