Extron electronic IN1404XT manual Status indicators, Ma i n Me nu

No

menu

display

Menu

Ma i n Me nu

Vi d e o Au d i o I n pu t Ou t p u t Ad v a n c ed

Menu

Menu or 15 sec.

Enter Menu

Menu

15 sec.

Vi de o B r i g h t ne s s Co n t r a s t

RGB Ga i n✫

Co l o r Sa t u r a t i o n✝ Hu e✝

Sh a r p n e s s✝

Gamma✝

No i s e F i l t e r✝

Comb / T r ap✝

Re s e t V i d e o

Au d i o

Ba s s

T r e b l e

Ba l a n c e

Re s e t Aud i o

I n pu t
S i gn a l Fo rma t
As p e c t	Ra t i o
Au t o Sw i t c h i n g
I n pu t Lab e l s		✝
Ho r i z T r a c k i n g
Ph a s e ✫
Ad v an c ed
Re s e t	I n pu t

15 sec.

15 sec.

15 sec.

Menu

Ou t pu t
Re s o l u t i o n
Re f r e s h		Ra t e ❖
Se am l e s s		Mod e
S i z e
Po s i t i on
Sy n c	Fo rma t
B l u e	Sc r e e n
Re s e t	Ou t p u t

Menu			15 sec.
	Ad v an c e d
	Fa c t o r y Re s e t
	Us e r	Memo r y
	Ba ud	Ra t e
	De l i me t e r s
	Re s e t	RS - 2 3 2

Sy s t em I n f o

This selection is only available for:

✻Composite video

✝Interlaced component, S-video, composite video ✫ RGBHV, RGBS, RGsB, and progresive component ❖ Inputs 3 and 4. Passive input 4 only

●The refresh rates that are available depend on the current resolution.

Figure 3-5 — Menu system flowchart

To enable seamless switching, input 4 must be configured as RGB passive (unscaled) on the Signal Format screen. However, once it is configured as passive and if input 4 is selected, on-screen menus are not displayed.

No video adjustments are available for the input 4 video signal when it is configured as passive (unscaled) but audio and other input variables are still adjustable. Because on-screen displays will be blanked for input 4 once it is configured as passive, it will be helpful to configure all of the input 4 options before you configure the input as passive. If, later, you need to change any of the input 4 settings, the easiest way is to temporarily set input 4 to one of the scaled output settings. See Signal Format screen in this chapter.

Alternatively, you can make the adjustments under RS-232 control.

Status indicators

Most of the Video and Audio menus (see Video menu and Audio menu in this chapter) and a select few Output menu operations (see Output menu in this chapter) are performed using on-screen status indicators (figure 3-6) that resemble slide bars but are controlled using the Menu and buttons.

Co n t r a s t

1 2 8

Figure 3-6 — Typical status indicator

Unless shown in the Video menu and Audio menu subparagraphs, adjusting the Video and Audio menu settings is accomplished as follows:

1. For the Video, Audio, and Input menu screens, select the input that you want to adjust by pressing that Input button.

IN1404XT Video Scaler and Switcher • Operation 3-5