Specific problems

The table below shows some common operating problems and their solutions.

Problem

Possible cause

Solution

No image appears.

Power.

Ensure that the video source, the

 

 

scaler, and the display are plugged

 

 

into a live AC power source and

 

 

the scaler is turned on.

 

 

 

 

No video input.

Check that the input device is

 

 

outputting a video signal.

 

 

 

 

No video output.

Press the Menu button, if the on-

 

 

screen display does not appear,

 

 

check the output connection.

 

 

 

 

The output signal is

Use the power up shortcuts to

 

incompatible.

select an output rate that is

 

 

compatible with the display.

 

 

 

 

The output resolution

Select an output resolution that is

 

is lower than the input

greater than or equal to the input

 

resolution.

resolution.

 

 

 

 

The display may not

Check the display’s sync capability

 

accept the output sync

and select the correct output sync.

 

format.

 

 

 

 

 

The input/output

Select Input>Advanced>Input

 

settings may be

Mode>Redetect Now.

 

incorrect or may have

 

 

been changed with

 

 

Lockout Changes

 

 

enabled.

 

 

 

 

The input is improperly Use the Input menu to select the

 

configured.

correct input format.

 

 

 

 

Freeze mode was

Deactivate freeze mode.

 

entered when the

 

 

image was black.

 

 

 

 

No audio output.

Power.

Ensure that the audio source, the

 

 

scaler, and the amplifier/speakers

 

 

are plugged into a live AC power

 

 

source and the scaler is turned on.

 

 

 

 

The source is incorrect.

Ensure that the source is

 

 

connected to the correct input and

 

 

that the volume has not been

 

 

turned down or muted.

 

 

 

The output is incorrect. The IN1404XT outputs line level

 

 

audio only. Ensure that it is

 

 

connected to a mixer/amplifier or

 

 

to amplified speakers.

 

 

 

 

Volume too low.

Increase the volume with the

 

 

scaler’s Volume button.

 

 

 

 

Audio may be muted.

Press the Mute Audio button.

 

 

 

The input source

Autoswitching is

Use the RS-232 AS0 command to

cannot be changed.

turned on via an

turn autoswitching off. See

 

RS-232 command.

chapter 4, Programmer’s Guide, for

 

 

details.

 

 

 

IN1404XT Video Scaler and Switcher • Operation 3-31

Page 51
Image 51
Extron electronic IN1404XT manual Specific problems, Problem Possible cause Solution No image appears