Extron electronic IN1404XT manual Edges

Problem	Possible cause	Solution
Image has jagged	(Interlaced video)	Select Input>Advanced>Scan Type
edges.	Even and odd fields.	and select Swap Fields to toggle
	are swapped.	the setting on.
Unable to select some	Desired settings are	Select Input>Advanced>Input
scaler settings.	outside the range of.	Mode and select User Defined to
	the predefined modes.	enable the full range of settings.
Total pixels setting	Horizontal blanking	Select Input>Advanced>H.
cannot be decreased.	may be too high	Blanking and reduce the setting to
		match the input signal.
	Active pixels setting	Select Input>Advanced>Active
	may be too high.	Area and reduce the setting to
		match the input signal.
Total pixels setting	Active pixels setting	Select Input>Advanced>Active
cannot be increased.	may be too low.	Area and increase the setting to
		match the input signal.
	Horizontal blanking	Select Input>Advanced>H.
	may be too high	Blanking and reduce the setting to
		match the input signal.
	Output resolution may	Select Output>Resolution and
	be too low.	select a setting that is greater than
		or equal to the active area.
Active lines setting	Vertical blanking	Select Input>Advanced>V.
cannot be increased.	may be too high	Blanking and reduce the setting to
		match the input signal.
	Output resolution may	Select Output>Resolution and
	be too low.	select a setting that is greater than
		or equal to the active area.
Horizontal blanking	Total pixels setting	Select Input>Advanced>Total
setting cannot be	may be too low.	Pixels and increase the setting to
increased.		match the input signal.
	Active pixels setting	Select Input>Advanced>Active
	may be too high.	Area and reduce the setting to
		match the input signal.
Vertical blanking.	Active lines setting	Select Input>Advanced>Active
	may be too high.	Area and reduce the setting to
		match the input signal.

IN1404XT Video Scaler and Switcher • Operation 3-35