Extron electronic manual 14 IN1404XT Video Scaler and Switcher Programmer’s Guide, Total pixels

Programmer’s Guide, cont’d

Command/Response Table for RS-232 Commands (Cont’d)

Command	ASCII Command	Response	Additional description
	(host to scaler)	(scaler to host)
Blanking (continued)
Set H blanking value to default	[BH@]	[OK]	Reset the horizontal blanking
			setting to its factory default (9).
View the H blanking value	[BH?]	[ X31 ]	Show the horizontal blanking
			setting.
Set a specific V blanking value	[BV X32 ]	[OK]	Specify the vertical blanking
			adjustment.
Increment V blanking value	[BV+]	[OK]	Increase the vertical blanking
			setting by one.
Decrement V blanking value	[BV-]	[OK]	Decrease the vertical blanking
			setting by one.
Set V blanking value to default	[BV@]	[OK]	Reset the vertical blanking
			setting to its factory default (9).
View the V blanking value	[BV?]	[ X32 ]	Show the vertical blanking
			setting.
Total pixels
	The total pixels and active pixels adjustments are interactive. Setting one of
	these variables may require adjusting the other.
Set a specific total pixel value	[TP X33 ]	[OK]	Specify the total pixels
			adjustment.
Increment total pixels value	[TP+]	[OK]	Increase the total pixels setting
			by one.
Decrement total pixels value	[TP-]	[OK]	Decrease the total pixels setting
			by one.
Set total pixels value to default	[TP@]	[OK]	Reset the total pixels setting to its
			factory default (9).
View the total pixels value	[TP?]	[ X33 ]	Show the total pixels setting.
Scan type
	1. The scan type settings are available for RGBHV, RGBS, RGsB, and
	progressive component video inputs only.
	2. Three scan type options are available; one, two, or all three can be turned
	on simultaneously.
Toggle interlaced on or off	[ST 0]	[OK]	Toggle the interlaced function on
			or off.
Toggle swapped fields on or off	[ST 1]	[OK]	Toggle the swapped fields
			function on or off.
Toggle invert sync on or off	[ST 2]	[OK]	Toggle the inverted sync function
			on or off.
View scan type value	[ST?]	[ X34 ]	View scan type settings.
Input mode
	The input mode settings are available for RGBHV, RGBS, RGsB, and
	progressive component video inputs only.
Set input mode to autodetect	[ST 0]	[OK]	Allows the scaler to automatically
			detect new input sampling rates
			and adjust itself accordingly.
Set input mode to lockout changes [ST 1]		[OK]	Prevents the scaler from
			switching back and forth
			between input sampling rates.

4-14 IN1404XT Video Scaler and Switcher • Programmer’s Guide