Extron electronic IN1404XT manual Freeze, Memory preset, Volume, Bass, Treble, Balance

Command/Response Table for RS-232 Commands (Cont’d)

Command	ASCII Command	Response	Additional description
	(host to scaler)	(scaler to host)
Pixel phase (continued)
View the sampling value	[PHS?]	[ X19 ]	Show the pixel sampling phase.
Freeze
Video freeze on	[FRZ1]	[OK]	Freeze the video output.
Video freeze off	[FRZ0]	[OK]	Unfreeze.
Toggle video freeze	[FRZ]	[OK]	Change the state of video freeze
			(off to on or on to off).
View freeze	[FRZ?]	[ X2 ]	View the status of the freeze
			setting.
Memory preset
Save preset	[MSAV X20 ]	[OK]	Save the video, balance, and
			input settings as preset X20 .

Recall preset	[MRCL X20 ]	[OK]	Recall preset
Reset preset	[MRST X20 ]	[OK]	Erase preset

X20

X20

settings.

settings.

Volume

Set volume	[VOL	X21	]	[OK]			Set volume for the selected input.
Increment level	[VOL+]			[OK]			Increase balance level for the
							selected input.
Decrement level	[VOL-]			[OK]			Decrease volume level for the
							selected input.
Set volume level to default	[VOL@]			[OK]			Set the volume to the default.
View volume level	[VOL?]			[	X21	]	View the volume level for the
							selected input.

Bass

Set bass	[BAS	X22	]	[OK]			Set bass for the selected input.
Increment level	[BAS+]			[OK]			Increase bass level for the
							selected input.
Decrement level	[BAS-]			[OK]			Decrease bass level for the
							selected input.
Set bass level to default	[BAS@]			[OK]			Set the input bass to the default.
View bass level	[BAS?]			[		]	View the bass level for the
					X22
							selected input.

Treble

Set treble	[TRE	X23	]	[OK]			Set treble for the selected input.
Increment level	[TRE+]			[OK]			Increase treble level for the
							selected input.
Decrement level	[TRE-]			[OK]			Decrease treble level for the
							selected input.
Set treble level to default	[TRE@]			[OK]			Set the input treble to the default.
View treble level	[TRE?]			[		]	View the treble level for the
					X23
							selected input.

Balance

Set balance	[BAL	X24	]	[OK]	Set balance for the selected input.
Increase balance right	[BALR]			[OK]	Move balance right for the
					selected input.
Increase balance left	[BALL]			[OK]	Move balance left for the selected
					input.
Set balance level to default (center) [BAL@]				[OK]	Set the input balance to the
					center.

IN1404XT Video Scaler and Switcher • Programmer’s Guide 4-11