Ref. No. 3B | Procedure 3A → 3B | Assembly of the spindle lock button and gear box. |
1. Push and hold the spindle lock button while inserting the gearbox block.
NOTE:
Confirm the direction of the spindle lock button. Place
In case of the spindle lock button hardly insert into the gearbox block, rotate the shaft of gearbox slowly by hand.
Make sure that the spring is set in the circule properly. 2. Tighten the 4 screws crossing.
NOTE:
Make sure to align the triangle mark of the gearbox with the housing.
Ref. No. 3C | Procedure 3A → 3B → 3C | Assembly of the switch. | |
|
| 1. | Wiring the thin white lead wire and the black motor lead wire on |
|
| the proper positions. | |
|
| 2. | Attach the battery terminals. |
|
| 3. | Wiring the white motor lead wire together with the thin white lead |
|
| wire. | |
|
| 4. | Place the white lead wires (for braking) passes through between |
|
| the black and white motor lead wires. | |
|
| 5. | Press fit the thin white lead wire (for braking) between screw |
|
| bosses firmly. | |
NOTE:
Be certain the lead wires are mounted in the proper position. Make sure that they are not set on the screw bosses or over the housing ribs.
8