OPERATION
Grasp the stock firmly with one hand and secure it against the fence. Use the optional work clamp or a
WARNING:
To avoid serious personal injury, always keep your hands outside the no hands zone; at least 3 in. (7.6 cm) from blade. Never perform any cutting operation freehand (without holding workpiece against the fence). The blade could grab the workpiece if it slips or twists.
Before turning on the saw, perform a dry run of the cutting operation just to make sure that no problems will occur when the cut is made.
Grasp the saw handle firmly then squeeze the switch trigger. Allow several seconds for the blade to reach maximum speed.
Slowly lower the blade into and through the workpiece. See Figure 26.
Release the switch trigger and allow the saw blade to stop rotating before raising the blade out of workpiece. Wait until the electric brake stops blade from turning before removing the workpiece from miter table.
COMPOUND MITER CUT
A compound miter cut is a cut made using a miter angle and a bevel angle at the same time. This type of cut is used to make picture frames, cut molding, make boxes with sloping sides, and for certain roof framing cuts.
To make this type of cut the control arm on the miter table must be rotated to the correct angle and the saw arm must be tilted to the correct bevel angle. Care should always be taken when making compound miter setups due to the interaction of the two angle settings.
Adjustments of miter and bevel settings are interdependent with one another. Each time you adjust the miter setting you change the effect of the bevel setting. Also, each time you adjust the bevel setting you change the effect of the miter setting.
It may take several settings to obtain the desired cut. The first angle setting should be checked after setting the second angle, since adjusting the second angle affects the first.
Once the two correct settings for a particular cut have been obtained, always make a test cut in scrap material before making a finish cut in good material.
TO MAKE A COMPOUND CUT WITH YOUR MITER SAW
Pull out the lock pin and lift saw arm to its full height.
Loosen the miter lock handle. Rotate the miter lock handle approximately
Press the miter lock plate down with your thumb and hold.
COMPOUND
MITER CUT
WORK CLAMP | Fig. 26 |
|
|
Rotate the control arm until the pointer aligns with the desired angle on the miter scale.
Release the miter lock plate.
Note: You can quickly locate 0°, 11.25°,15°, 22.5°, 31.62°,and 45° left or right by releasing the miter lock plate as you rotate the control arm. The miter lock plate will seat itself in one of the positive stop notches, located in miter table frame.
Tighten the miter lock handle securely.
WARNING:
To avoid serious personal injury, always tighten the miter lock handle securely before making a cut. Failure to do so could result in movement of the control arm or miter table while making a cut.
Loosen the bevel lock knob and move the saw arm to the left to the desired bevel angle.
Bevel angles can be set from 0û to 48û.
Once the saw arm has been set at the desired angle, securely tighten the bevel lock knob.
Recheck miter angle setting. Make a test cut in scrap material.
Place the workpiece flat on the miter table with one edge securely against the fence. If the board is warped, place the convex side against the fence. If the concave edge of a board could collapse on the blade at the end of the cut, jamming the blade. See Figures 30 and 31.
When cutting long pieces of lumber or molding, support the opposite end of the stock with a roller stand or with a work surface level with the saw table. See Figure 28.
21