LASER GUIDE
MOUNTING THE EXACTLINEª LASER GUIDE
See Figure 33 .
Unplug your saw.
WARNING:
Failure to unplug your saw could result in accidental starting causing possible serious personal injury.
See "To Install Blade" in the adjustments section of this operator's manual.
Make sure inner blade washer is in place before posi- tioning saw blade on the spindle of your saw.
Note: The laser guide replaces the outer blade washer.
Place the laser guide onto the spindle, aligning the double "D" flats in the laser guide with the flats on the spindle.
Position flat surface of laser guide against the blade. Warning labels are visible when laser guide is mounted properly.
Depress spindle lock button and secure laser guide us- ing blade wrench provided.
Note: The hex key bolt has left hand threads. Turn bolt counterclockwise to tighten.
Using the blade wrench provided with your saw, tighten bolt securely.
Return the blade wrench to the wrench storage area.
Replace the lower blade guard and blade bolt cover.
Retighten phillips screw securing blade bolt cover. Tighten screw securely.
DANGER:
Laser radiation. Avoid direct eye contact with light source.
Make several practice cuts on different styles and thickness of material.
Follow the directions below for using your Laser Guide.
Removing Your Mark:
Position the laser line near the left edge of your mark on the work surface in order to remove the mark.
To Cut Your Mark:
Position the laser line near or over your mark on the work surface in order to cut the mark.
To Leave Your Mark:
Position the laser line near the right edge of your mark on the work surface in order to leave the mark.
After you have become familiar with using your Laser Guide, you will be able to remove, cut, or leave your mark on the work surface. Practice will teach you the correct position for aligning the laser line with your mark.
BLADE |
|
LASER |
|
GUIDE |
|
HEX KEY | SPINDLE |
| |
BOLT |
|
| INNER BLADE |
| WASHER |
BLADE WRENCH | Fig. 33 |
OPERATION
See Figure 34.
The laser guide will generate a red colored line on the work surface when the saw blade is spinning above 500 rpm. The red laser line will appear as a broken line on the workpiece when the blade assembly is in the uppermost position and the motor switch is activated. This broken line will let you see your mark and your laser guide line at the same time, and will assist you in lining up your mark for more accurate cutting of the workpiece.
ALIGNMENT
Align the laser line and your mark with the blade at the uppermost position. Once both lines are in alignment, do not move the workpiece until after you have finished cutting.
As the blade assembly is lowered toward the workpiece, the broken line will become solid.
BROKEN
RED LINE
Fig. 34
26